India customer come in person to check the machine produced for him

India customer come in person to check the machine produced for him

This customer came from India, he bought a door frame machine from us.

This is a small machine, without decoiler and cutter and receiving table.

The only part of this machine is the main roll forming machine.

At first this machine finish time is a little delay, customer not happy.

But after he visited us, he said his afraid mind was calm down.

He said our machine quality is better than the other factories.

Here I attached our machine parameters for you check.

Size of the main part: about 3200х 800х 1500mm
Weight of main part: 2.5 tons
Voltage: 415 v 50 hz 3 phase
Frame type: Middle plate weld
Transmission mode: By gear
Material of rollers: Cr12mov
Material of shafts: 45# steel with tempering
Diameter of shafts: φ 40 mm
Number of rollers: 15 rollers
Forming speed: 8-10m per minutes
Transmission motor power: 3 kw
Processing material thickness: 0.5mm